The Xbox is a fantastic package alone. However, with games like Call of Duty 5, Modern Warfare, and Modern Warfare 2, a lot more people find good reasons to get a new said game console, or its accessories. One such modification is really a response to create a rapid fire modded Xbox controller. Listed below are the steps concerning how to modify your original controller with a rapid fire controller.
Step 1. Unscrewing the controller
Prior to starting taking your controller apart, require a close look at the controller first and try to remember which parts go where since you will eventually have to put everything back again. Begin by unscrewing every one of the visible screws behind. Next, before you tug involved, remove the batteries to disclose the hidden screws. Remove these as well.
2. Preparing the truth
With all the controller facing down, slowly and thoroughly separate leading half of the casing in the circuit board. An opening in the case will ultimately need to be made. Remember this before putting things back.
Step three. Placing The Rapid Fire Button
While other ways of modifying the controller don't involve installing a fresh button, this specific guide does. Not only does this help you to adjust the pace of rapid fire, it minimizes tampering along with other elements of the circuit board, thereby minimizing the risk of damaging your modded Xbox 360 controller.
Remember, kits for that rapid fire controller are available easily. It's the button out of this kit which will be placed from the hole in the casing, so place it gently ahead of the circuit board is returned. You might want to snip out several flaps to make means for the wires with the kit. This can be done with either a cutter or even a pair of scissors.
Step four. Soldering
Let's assume that you are aware how to properly use a soldering iron, attach the red wire to the leftmost pin of the 4-pin horizontal series, as the blue wire solders to the rightmost pin of the same series. The black (or green sometimes) wire attaches to the center of the three vertical series right with the switch.
Soldering is the most crucial step to making the modded Xbox controller. The reason being mistakes made in this stage can permanently damage your controller.
Step 5. Putting everything back
Carefully taking note of the wires, make an effort to close the circuit board as well as the casing. This may be a little tricky as the new wires are certain to get in the way of things. Find a way for these wires to occupy the empty spaces instead of herniated. You might support the modded Xbox controller facedown so that the buttons don't fall and maneuvering the wires really are a little easier. Position the casings together but don't return the screws yet.
You now need to check if the rapid fire buttons work. If they don't, you may have to restart both your console as well as the now modded Xbox 360 controller. This should solve the situation. When it doesn't then you can have to go from the steps again to check.